Jump to content

Sorry!

This site is in read-only mode right now. You can browse all our old topics (and there's a lot of them) but you won't be able to add to them.

Injection Pain

olympia
 Share

Recommended Posts

olympia Senior member

olympia

Posted
Posted

Had my fourth pin on friday night in the left delt and as i pushed in the needle i think i hit a nerve or something as got a spasm and a bang! down my arm then its been aching like a dick in a lambing ring ever since . Had bad sleeps last two nights because of it. Was a bit niggly in training today.

Anyone had this or know what happened? Its put me off doing my delts again. Was thinking of switching to the quads. Good idea?

Link to comment
Share on other sites
Daz69 Senior member

Daz69

Posted
Posted
random question...but what happens if you always just inject glutes (alt between left and right) or is that a big nono?

You may eventually get lumps in the muscle, at the point of regular injection.....

:wink:

Link to comment
Share on other sites
severe Senior member

severe

Posted
Posted
Glutes are painless and easy to do.

:nod:

Super easy if you can reach them without cramping up.

I prefer quads. Had no twitches, and only 3 lava lamps :)

I gave up on glutes as they a bitch to reach properly.

Link to comment
Share on other sites
MullacT Member

MullacT

Posted
Posted
Higher chance of hitting in your quads than in your delts bro.

I do quads all the time. Never had an issue once... other than when i injected Stan depot into it. Hurt like a motherfuker :pfft:

Lucky guy. I've hit nerves a couple of times in my quad and I shat myself. No pain though so I was lucky

Link to comment
Share on other sites
Anaru84 Junior member

Anaru84

Posted
Posted
random question...but what happens if you always just inject glutes (alt between left and right) or is that a big nono?

yes a big nono and can cause abscesses in your nono too lol

I found a sweet spot on my quad, so i was stickin prop and tren into the same spot, EOD 1-2ml in each quad, then i noticed a big bubble on my leg, id push it and no pain but it was like air was moving inside the muscle, i stick a needle in and draw out a heap of puss and blood mixed together. off to the hospital, drained as much they could and put me on antibiotics.

I got an abscess from injecting into the same muscle too many times in a row. now i rotate injection sites, glutes, quads, shoulders, lats, chest.

Link to comment
Share on other sites
severe Senior member

severe

Posted
Posted
so how many times is too many?

Well, I have done over 100 into the quads, and no infections yet.

Anaru, any possibility of contamination/sterility issues while going through the routine of pinning?

I once sucked up a piece of rubber from the stopper, and it was tiny. I wondered how many of these bits must go into people who don't notice. It was a speck and almost not noticed. Something like that could cause problems I am sure.

Not discounting your experience though. Just putting out options.

Link to comment
Share on other sites
Anaru84 Junior member

Anaru84

Posted
Posted

BAZ and Servere

too many is doing it in the same spot every day for about a week.

yeah ive stuck hundreds of pins everywhere too but not on consecutive days like i did when i got the abscess.

If was due to dirty gear then my body would have been riddled with abscesses as i continued to use the gear for 6weeks after. same batch at least. My gear is filtered twice, once with a vacuum pump into a large vial, then again using whatman filters when going into the 10ml vials. ill also add that the rubbers are soaked in isopropyl alc and dried, and the vials autoclaved and bake dried in a portable oven just for baking vials lol... i dont do the process myself but i trust the person doin it as he is a close friend, who uses it himself so i dont think he'd risk his own health too...

Link to comment
Share on other sites
severe Senior member

severe

Posted
Posted
servere- who knows maybe some dust or something went on the pin... possible but i put it down to the constant pinning of the one area on consecutive days for too long

Sweet as. I was just wondering what may have caused it.

Link to comment
Share on other sites
samoan_muscle Veteran member

samoan_muscle

Posted
Posted
servere- who knows maybe some dust or something went on the pin... possible but i put it down to the constant pinning of the one area on consecutive days for too long

Sweet as. I was just wondering what may have caused it.

Maybe he was blazed?

LOL - nah just pulling your leg cuz.

Che.

Link to comment
Share on other sites
Sifo-Dyas Member

Sifo-Dyas

Posted
Posted

I have injected almost everywhere :shock:

Have done delts and quads hundreds of times. Scar tissue in the delts can become a minor restriction but can be massaged out.

Quads have a greater surface area and don't have any problems there other than the odd nerve.

Injection pain is quite common with strong gear, or fast acting gear due to the solvent content. Especially Test propionate, Trenbolone Acetate and similar faster esters.

I am currently running some Testosterone Enanthate that is pushing 300mg/ml and it has some pain attached to it.

I prefer to inject the painful ones into the delts as there is less nerves and the pain is much easier to tolerate there. I had been limping for a few days after whacking a couple of mls into each quad!

So the strength of the gear, the ester and the amount injected will all play a part as to the pain level of gear. I will not go into poor quality or "dirty" gear, that is a completely different story.

So if gear is painful in the quads, inject it into the delts. regardless of where you inject your gear, make sure you use a needle long enough to go deep into the muscle and always draw back before injecting to make sure you are not in a vein. :)

Link to comment
Share on other sites
jimjim83 Senior member

jimjim83

Posted
Posted
I have injected almost everywhere :shock:

Have done delts and quads hundreds of times. Scar tissue in the delts can become a minor restriction but can be massaged out.

Quads have a greater surface area and don't have any problems there other than the odd nerve.

Injection pain is quite common with strong gear, or fast acting gear due to the solvent content. Especially Test propionate, Trenbolone Acetate and similar faster esters.

I am currently running some Testosterone Enanthate that is pushing 300mg/ml and it has some pain attached to it.

I prefer to inject the painful ones into the delts as there is less nerves and the pain is much easier to tolerate there. I had been limping for a few days after whacking a couple of mls into each quad!

So the strength of the gear, the ester and the amount injected will all play a part as to the pain level of gear. I will not go into poor quality or "dirty" gear, that is a completely different story.

So if gear is painful in the quads, inject it into the delts. regardless of where you inject your gear, make sure you use a needle long enough to go deep into the muscle and always draw back before injecting to make sure you are not in a vein. :)

What! Is 300mg stuff priced the same or more? If more then wouldnt it equal itself out and just be less painful to inject more at a lesser dose?

Link to comment
Share on other sites
severe Senior member

severe

Posted
Posted
I am currently running some Testosterone Enanthate that is pushing 300mg/ml and it has some pain attached to it.

I feel your pain. It's a bitch because it isn't an instant pain, but a slow build up. Oh well, no pain, no gain.

Link to comment
Share on other sites
Sifo-Dyas Member

Sifo-Dyas

Posted
Posted
I have injected almost everywhere :shock:

Have done delts and quads hundreds of times. Scar tissue in the delts can become a minor restriction but can be massaged out.

Quads have a greater surface area and don't have any problems there other than the odd nerve.

Injection pain is quite common with strong gear, or fast acting gear due to the solvent content. Especially Test propionate, Trenbolone Acetate and similar faster esters.

I am currently running some Testosterone Enanthate that is pushing 300mg/ml and it has some pain attached to it.

I prefer to inject the painful ones into the delts as there is less nerves and the pain is much easier to tolerate there. I had been limping for a few days after whacking a couple of mls into each quad!

So the strength of the gear, the ester and the amount injected will all play a part as to the pain level of gear. I will not go into poor quality or "dirty" gear, that is a completely different story.

So if gear is painful in the quads, inject it into the delts. regardless of where you inject your gear, make sure you use a needle long enough to go deep into the muscle and always draw back before injecting to make sure you are not in a vein. :)

What! Is 300mg stuff priced the same or more? If more then wouldnt it equal itself out and just be less painful to inject more at a lesser dose?

Jimjim you do ask the best questions lol -

It is the same price but the gear is a tad over-strength \:D/ ...I know that when it comes to the Enanthate ester the solvent content is fairly low as it is very easy to hold in solution and solvents are always a % game of the total volume and nothing to do with how strong the gear is in the case of Enanthate.

this said I can only conclude that the stronger the gear itself is, the more painful it will be to inject.

And you know the doses I like to play with so my first shot was 2ml Enanthate, 1ml Propionate and 0.5ml Masteron (2.5ml total) all over strength and all in one quad. the injection was smooth and painless. Next morning the leg was slow to get moving and by evening I had a decent limp lol.

All part of the game and severe is seems to be playing the same game :wink:

Link to comment
Share on other sites
 Share
Go to topic listing


  • Popular Contributors

    Nobody has received reputation this week.

×
×
  • Create New...